OpenFiler 2.99

Summary

This is part 1 in a proof of concept serious involving the creation of a RAID 1 iSCSI Target using OpenFiler 2.13 and Vmware Server 2. We will purposely fail one of the virtual disks in the array rebuild the array and verify the data. In part one of the series we will create the Raid 1 array. In subsequent parts we will create an ISCSI Target, connect Windows Vista using iSCSI Initiator and simulate RAID 1 drive failure and recovery. The OpenFiler vmware appliance is free to download and use. The installation of both Vmware Server 2 and OpenFiler 2.13 vmware appliance will not be covered here.
Create VMware virtual disks

From the VMware Server 2 web administration create two 50 MB disks for the OpenFiler VMware guest accepting the VMware defaults.
Create Raid Partitions

As seen in Figure 1, navigate to openfiler > Volumes > Block Devices and select the first of our newly created disks /dev/sdb.

FIGURE 1: opefiler > Volumes > Block Devices



Create a RAID array partition by selecting Partition Type: “RAID array member” for the entire cylinder range (default) and clicking “Create”. See Figure 2. The resulting RAID partition should like as seen in Figure 3. Repeat the previous steps to create a RAID partition for /dev/sdc


FIGURE 2: opefiler > Volumes > Block Devices > /dev/sdb



FIGURE 3: openfiler > Volumes > Block Devices > /dev/sdb


Create New Raid 1 Array

Once the two raid devices have been created navigate to openfiler > Volumes > Software Raid as seen in Figure 4 below. Select RAID-1 from the drop down menu, leave the chunk size at default, select the two raid devices as seen in Figure 4 and click “Add array”. The resulting raid array information will be displayed as seen in Figure 5.

Figure 4: openfiler > Volumes > Software Raid



Figure 5: openfiler > Volumes > Software Raid


Create New Volume Group

Navigate to openfiler > Volumes > Volume Groups and create the new volume group “volgroupraid001”. If this is not your preferred volume group naming convention, change it to your liking. After entering your “Volume group name”, select our newly created Raid 1 volume /dev/md0 and click “Add volume group” as seen in Figure 6. The resulting Volume Group is displayed as seen in Figure 7.

Figure 6: openfile > Volumes > Volume Groups



Figure 7: openfiler > Volumes > Volume Groups


Create New Volume

Navigate to openfiler > Volume>Add Volume select our “volgroupraid001” volume group, enter the name our new volume “volraid001”, fill in a description, enter the Required Space” (32MB) and be sure to select the proper “Filesystem Type” of iSCSI. Click “Create” when ready. See Figure 8 below. The resulting Volume Group will be as seen in Figure 9.

Figure 8: openfiler > Volume > Add Volume

Figure 9: openfiler > Volumes > Manager Volumes



In our next section we will create the OpenFiler iSCSI Target using our newly created RAID 1 volume.

OpenFiler 2.99 - Attempted to Create Software Raid 1 Array - Failed...

Heres the code you need to get RAID1 working on Openfiler 2.99:

You need to type the following commands into the shell.

Code:
conary update mdadm=openfiler.rpath.org@rpl:devel/2.6.4-0.2-1

This will install the correct mdadm files, once installed type the next command in.

Code:
ln -s /sbin/lvm /usr/sbin/lvm

This ensures that the GUI is populated correctly.
This will then allow you to create all of the software RAID types without issue.

I extracted this info from here: http://www.everything-virtual.com/?p=349